Odyssey SRS Light Reset - Solved!
#1
Thread Starter
Join Date: Jul 2004
Location: Fort Meade, MD, USA
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Odyssey SRS Light Reset - Solved!
My 1997 Odyssey's SRS had been on for a few months. Looking through the forums, I found the reset procedures for other Honda models. The only problem was finding the stupid "MES plug". It is not in the same place as the Accords and Civics.
I finally found it after dissassembling my lower driver's side dashboard (3 screws - one in the change drawer, and some clips). The MES plug is located high on the left side plugged into a yellow dummy connector which is attached to a metal bracket.
Once found, I used the following procedure:
1) Turn ignition switch off
2) Connect the scs service connector to the MES connector. (I used a paper clip)
3) Turn ignition switch to on
4) The SRS indicator light will come on for about 6 seconds, and then go off. Remove the SCS service connector from the MES connector within 4 seconds after the light comes on
5) The SRS indicator will come on again. Reconnect the SCS service connector to the MES connector within 4 seconds after the light comes on.
6) When the SRS indicator light goes off, remove the SCS service connector from the MES connector within 4 seconds.
7) The SRS indicator light will blink 2 times indicating that the memory has been erased
8)Turn the ignition switch to off and wait for 10 seconds.
Hope this helps.
I finally found it after dissassembling my lower driver's side dashboard (3 screws - one in the change drawer, and some clips). The MES plug is located high on the left side plugged into a yellow dummy connector which is attached to a metal bracket.
Once found, I used the following procedure:
1) Turn ignition switch off
2) Connect the scs service connector to the MES connector. (I used a paper clip)
3) Turn ignition switch to on
4) The SRS indicator light will come on for about 6 seconds, and then go off. Remove the SCS service connector from the MES connector within 4 seconds after the light comes on
5) The SRS indicator will come on again. Reconnect the SCS service connector to the MES connector within 4 seconds after the light comes on.
6) When the SRS indicator light goes off, remove the SCS service connector from the MES connector within 4 seconds.
7) The SRS indicator light will blink 2 times indicating that the memory has been erased
8)Turn the ignition switch to off and wait for 10 seconds.
Hope this helps.
Thread
Thread Starter
Forum
Replies
Last Post
DumpedSi
Honda Civic / Del Sol (1992 - 2000)
8
09-11-2003 08:42 PM