can somebody double check my vacume lines for my crx hf w/b16
08-23-2003, 12:12 PM
#1
Thread Starter
Join Date: Apr 2003
Posts: 301
Likes: 0
Received 0 Likes
on
0 Posts
can somebody double check my vacume lines for my crx hf w/b16
this is my hf vacume lines running to my first gen b16. one side of the map sensor line is capped off. the other side is running to to the back of my manifold where i have it tee'd a couple of times with my fpr line, boost gauge, and blow off valve. the line running from the purge valves are going to my black canister and the throttle body.
08-23-2003, 12:26 PM
#2
Honda-Tech Member
Re: can somebody double check my vacume lines for my crx hf w/b16 (crx1856)
Here recheck them using this pic, its hard for me to see if everything is ok because the pic is only focusing on the map sensor.
From what I can see though, everything looks good.
From what I can see though, everything looks good.
08-23-2003, 12:31 PM
#4
Thread Starter
Join Date: Apr 2003
Posts: 301
Likes: 0
Received 0 Likes
on
0 Posts
Re: can somebody double check my vacume lines for my crx hf w/b16 (crx1856)
line #10 goes into a port in the manifold i don't have. 1 and 12 are tee'd into where line 10 would go. is that right?
08-23-2003, 03:43 PM
#5
Honda-Tech Member
Join Date: Apr 2003
Location: 60ft garage, CA, USA
Posts: 5,365
Likes: 0
Received 0 Likes
on
0 Posts
Re: can somebody double check my vacume lines for my crx hf w/b16 (crx1856)
MAP hose goes to a vacuum fitting on the throttle body itself (like it shows in the hose routing pic). I wouldnt tee anything off of that particular line. As for the others u should be fine.
Thread
Thread Starter
Forum
Replies
Last Post
crx1856
Honda CRX / EF Civic (1988 - 1991)
6
08-18-2003 10:55 AM
crx1856
Hybrid / Engine Swaps
3
08-18-2003 08:46 AM
