94+ Integra seats in a CRX instructions?
#3
Junior Member
Join Date: Oct 2001
Location: Arlington, TX, USA
Posts: 657
Likes: 0
Received 0 Likes
on
0 Posts
Re: 94+ Integra seats in a CRX instructions? (hondaspeed85)
1. measure how far apart ur stock brackets are from each other.
2. take off the outer bracket on the Integ seats.
3. put the outer bracket off the crx seat at the apporpriate distance (keep in mind that you might have to make new holes and use bolts with lock washers and nuts to make sure its secure...its tricky but not too hard)
4. shorten the wire thing that pulls the adjuster thing on the outer bracket then reattatch and make sure it pulls it well enough so you can adjust.
5. reinstall the seats...only the front 2 and rear outer bracket will be bolted in but it holds on tight.
i have done this for 2 different cars already and no extra drillin onto the car...the only drilling i did was holes on the seats and bracket where i had to bold the outer bracket to the seat. the seats that were in both cars were very sturdy and tight...actually i could even say that it was tighter than my stock CRX si seats in my car. hope u guys can understand these instructions...i dont know if theres a better way to do this but i know this is the best way i could find out without drillin holes into the bottom of the car. let me know how things go, GOOD LUCK!!!
2. take off the outer bracket on the Integ seats.
3. put the outer bracket off the crx seat at the apporpriate distance (keep in mind that you might have to make new holes and use bolts with lock washers and nuts to make sure its secure...its tricky but not too hard)
4. shorten the wire thing that pulls the adjuster thing on the outer bracket then reattatch and make sure it pulls it well enough so you can adjust.
5. reinstall the seats...only the front 2 and rear outer bracket will be bolted in but it holds on tight.
i have done this for 2 different cars already and no extra drillin onto the car...the only drilling i did was holes on the seats and bracket where i had to bold the outer bracket to the seat. the seats that were in both cars were very sturdy and tight...actually i could even say that it was tighter than my stock CRX si seats in my car. hope u guys can understand these instructions...i dont know if theres a better way to do this but i know this is the best way i could find out without drillin holes into the bottom of the car. let me know how things go, GOOD LUCK!!!
#6
Honda-Tech Member
Join Date: Apr 2005
Location: Boston.MA
Posts: 188
Likes: 0
Received 0 Likes
on
0 Posts
Re: 94+ Integra seats in a CRX instructions? (ThE bEe GuY)
you need to do a seat pan swap
[URL]https://honda-tech.com/zerothread?id=988203URL]
and heres a pic of mine
[URL]https://honda-tech.com/zerothread?id=988203URL]
and heres a pic of mine
Thread
Thread Starter
Forum
Replies
Last Post
hondaguyef
Want to Buy
2
05-26-2005 07:30 PM
crux131
Honda CRX / EF Civic (1988 - 1991)
2
01-31-2004 11:41 AM
camera obscura
Honda CRX / EF Civic (1988 - 1991)
2
03-25-2003 08:04 PM