slamdlude
Offline
223 posts [100%]
montgomery alabama
4-10-2006
|
| « Re: Help programming factory remote for 1998 prelude (slamdlude) | « » 6:21 PM 5/13/2008 |
Reply
Edit
|
Programming instructions for 98 prelude
1: hold your key in your right hand and remote in your left hand, insert key into ignition
2: has to be performed three times (each a,b,c cycle within 5 seconds)
2a: turn key to ONposition (not to start, just to on)
2b: press and release UNLOCK button on the transmitter
2c: turn ignition switch back toLOCK position but do not remove the key
3: within 5 seconds turn the key back to the on position
4: press and release the unlock button on the same transmitter, the power door locks will cycle to show that you are in programming mode
5: within 10 seconds press and release the unlock button on the same transmitter. the door locks should cycle again
6: repeat step five for any other transmitters you have
7: turn key to lock position to exit program mode
disclaimer: I am not responsible for anything that happens when using these instructions use them at your own risk
Modified by slamdlude at 5:35 PM 5/13/2008
93 Prelude H22 swap
Turbo coming eventually
|
