As far as bolt ons go....same I contacted all major manufacturers of bolt ons like AEM, Borla, etc...and same thing its not on their list to r&d. So long story short, you will probably be hard pressed to find parts for it in the near future. Good luck tho.

http://www.hondamarketplace.co...98806
buy my parts...no junk here

Official bring NOFX back #008
If you ban NOFX, delete all the threads she took the time and hours she has done for you and everyone on this web site.

K-sport has released a full coilover setup for 1G CRVs That would be the best way to do it, but Skunk2 also makes coilover sleeves that go over the stock shocks.

You can just get an intake made for CRVs on ebay for cheap and then get a K&N filter for it. That's what we did on ours...and we got some good silicone couplers.

For headers you can use anything made for a B18 nonVTEC engine. Our B20s have basically the same head. So shop for Integra LS B18 nonVTEC headers and you should be good (I am not 100% sure if there are oil pan clearance issues though).

There is a huge amount of parts made for B-series engines, so there is really a ton of potential.

-Blue, black, gray primer, carbon fiber, Bondo

Someone actually make suspension goodies for a 1st gen! There is a God!

Official bring NOFX back #008
If you ban NOFX, delete all the threads she took the time and hours she has done for you and everyone on this web site.

I do not understand what you are trying to say...

-Blue, black, gray primer, carbon fiber, Bondo