vietdragontekx

i had the pump and reservor removed for about half a year now. so there no power steering at all. now i want to go back to power steering. Do i just put pump back on and reservor and line and etc and just fill with power steering fluid and start the car? Or there something i need to do before i do all this?

98vtec

given that you took out everything without kinking a tube etc, then you should be able to just put it back like you had it. be sure not to forget about the cooler.

vietdragontekx

cooler? i only took out the rubber line going to the hard line near the back of firewall and the reservor and ps pump.

Hawkze_2.3

Yeah, there's a PS cooler in front of the radiator...but if you just put everything back in how you had it you should be able to get it working.

mgags7

If I were you, I'd fill it, then use the helms' draining procedure once to get that stagnant fluid out, and get some fresh stuff in there. Plus, that will aid in burping the air out as well.

vietdragontekx

i don't have a helm manual , do u know the procedure?

mgags7

basically, you just set it up so that 1) the low pressure return hose is venting into a waste container and 2)you didn't leave anything open that's gonna spill

vietdragontekx

so if i get this right, i hook everything up, fill the reservor then remove the return ine and put it on a waste container and turn on the car?

mgags7

you don't want to fill the reservoir with new fluid if you're just gonna drain the old crap out.

There is a special procedure for it, I really recommend getting a manual. I don't remember it off the top of my head, and I'm not sure you're ready to figure this out alone.

vietdragontekx

thx

mgags7

found it

vietdragontekx

thx a lot