Electrical junkies please help...
01-28-2007, 07:10 PM
#1
Honda-Tech Member
Thread Starter
Join Date: Jun 2003
Location: Dirty South
Posts: 410
Likes: 0
Received 0 Likes
on
0 Posts
Electrical junkies please help...
I keep frying my ignition module. Ive replaced it 3 times now. When I put a new one in, itll start the car one time, then when I shut the car off, its fried. I have no idea what going on. Things Ive done to correct the problem: new cap and rotor, new plugs, new plug wires on the way, checked all grounds. Its not throwing any codes either. Anyone got a clue? Last hope before I get a Honda tech out to the house.
01-29-2007, 03:23 AM
#3
I forgot more about hondas then you will ever know....
Join Date: Feb 2001
Location: hop,skip, and a jump from the city,, new friggin york, USA
Posts: 5,310
Likes: 0
Received 1 Like
on
1 Post
Re: Electrical junkies please help... (C-West Civic)
check the inside of the dizzy for bad insulation on the wiring. these cars are getting older, and i have seen it 2x before. the insulation is hard/brittle, and flakes off causing a short.
01-29-2007, 03:46 PM
#4
Honda-Tech Member
Thread Starter
Join Date: Jun 2003
Location: Dirty South
Posts: 410
Likes: 0
Received 0 Likes
on
0 Posts
Re: Electrical junkies please help... (Rodney)
You mean just the wires sheathing ( insulation )? Have any ideas if that checks out ok? Going by memory they seemed to be ok, but ill get out there and give it a good look over.
Thread
Thread Starter
Forum
Replies
Last Post